Sunday, February 24, 2008

Making the power connections

1. Set the parking brake and disconnect the negative terminal from your battery to prevent any electrical short.

Route the red wire from your amp wiring kit through a hole in your vehicle's firewall.

2. Remove the red power wire from your amp wiring kit (usually 16-20 feet in length). Locate a hole on the firewall; most cars have a predrilled one you can use. If not, you'll have to find a good place to drill one. If you have problems, contact Crutchfield technical support at the phone number listed on your invoice. Once you've found or drilled a suitable hole, run the power wire through the hole into the engine compartment.

For AMP Accessories, connectors, wire and more go to:

No comments: